Section 6 (Electronically Controlled Continuously Variable Transmission (ECVT)): Removal: Transaxle

WARNING: This page is about a different variant/trim than selected.

To remove the transaxle, follow the engine removal procedure. For additional information, refer to REMOVAL . Before removing the engine and transaxle from the vehicle, remove the drain plug and drain the transmission fluid.
- To install, tighten to 40 Nm (30 lb-ft).
NOTE: Do not drain the oil when removing the engine to service the transaxle.

NOTE: Inspect the plug and washer for damage and install a new plug if necessary.

Fig 1: Locating Drain Plug
Courtesy of FORD MOTOR CO.