LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Electronically Controlled Continuously Variable Transmission (ECVT)) >> In-Vehicle Repair >> Differential Seals - LH >> Removal

Differential Seals - LH: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Turn the ignition to the OFF position.
  3. Remove the 7 screws and the underbody cover.
    Fig 1: Locating Underbody Cover Screws
    G06257240Courtesy of FORD MOTOR CO.
  4. Remove the drain plug and drain the transmission fluid.
    Fig 2: Locating Drain Plug
    G06275478Courtesy of FORD MOTOR CO.
  5. Remove the LH halfshaft. For additional information, refer to REMOVAL .
  6. Using the Slide Hammer and Input Shaft Oil Seal Remover, remove and discard the LH differential seal.
    Fig 3: Identifying Slide Hammer & Input Shaft Oil Seal Remover
    G06275486Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals