Turbine Shaft Speed (TSS) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the 6 pin-type retainers and the LH front structure-to-subframe splash shield.

Fig 1: Locating Pin-Type Retainers And LH Front Structure-To-Subframe Splash Shield
Courtesy of FORD MOTOR CO.
Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.

Fig 2: Locating Turbine Shaft Speed (TSS) Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the bolt and the TSS sensor.

Fig 3: Locating Bolt And TSS Sensor

Courtesy of FORD MOTOR CO.