Turbine Shaft Speed (TSS) Sensor: Installation

WARNING: This page is about a different variant/trim than selected.

Install the TSS sensor and the bolt.
- Tighten to 10 Nm (89 lb-in).
Fig 1: Locating Bolt And TSS Sensor
Courtesy of FORD MOTOR CO.
Connect the TSS sensor electrical connector.

Fig 2: Locating Turbine Shaft Speed (TSS) Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Install the LH front structure-to-subframe splash shield and the 6 pin-type retainers.

Fig 3: Locating LH Front Structure-To-Subframe Splash Shield And Pin-Type Retainers
Courtesy of FORD MOTOR CO.
Fill the transaxle with clean transmission fluid.

Fig 4: Locating Transmission Fluid Level Indicator
Courtesy of FORD MOTOR CO.
Start the engine and let it run for 3 minutes. Move the range selector lever into each gear position. Check the transmission fluid level, making sure that the transmission fluid is at the correct level.