Transaxle Support Insulator - Anti-Roll: Installation

All vehicles 

1. Position the roll restrictor in place and install the bolts.
   • Tighten to 90 Nm (66 lb-ft).
   Fig 1: Locating Bolts And Roll Restrictor

   Courtesy of FORD MOTOR CO.

   Vehicles equipped with a 3.0L engine 

2. Install the Y-pipe. For additional information, refer to EXHAUST SYSTEM .

   All vehicles 

3. Install the underbody cover and the screws.
   Fig 2: Locating Underbody Cover And Screws

   Courtesy of FORD MOTOR CO.