LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transaxle - 6F35) >> In-Vehicle Repair >> Transaxle Filler Tube >> Installation

Transaxle Filler Tube: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Inspect the O-ring seal on the transaxle filler tube for damage and install a new O-ring if needed. Lubricate the O-ring seal with clean automatic transmission fluid.
    Fig 1: Locating O-Ring Seal
    G06278298Courtesy of FORD MOTOR CO.
  2. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals