Halfshaft Seal - RH, Front Wheel Drive (FWD): Installation

WARNING: This page is about a different variant/trim than selected.

Install a new halfshaft seal on the Seal Installer and Handle.

Fig 1: Locating Seal Installer And Handle
Courtesy of FORD MOTOR CO.
Using the Seal Installer and Handle, install the RH halfshaft seal.

Fig 2: Installing RH Halfshaft Seal
Courtesy of FORD MOTOR CO.
Install the front RH halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS .
Fill the transaxle with clean transmission fluid.

Fig 3: Locating Transmission Fluid Level Indicator
Courtesy of FORD MOTOR CO.
Start the engine and let it run for 3 minutes. Move the range selector lever into each gear position. Check the transmission fluid level, making sure that the transmission fluid is at the correct level.