Special Tool(s)

WARNING: This page is about a different variant/trim than selected.

SPECIAL TOOL CHART

Courtesy of FORD MOTOR CO.	Compressor, Forward Clutch Spring 307-574 (includes 307-574/1 and 307-574/2)
Courtesy of FORD MOTOR CO.	Compressor, Forward/Intermediate Spring 307-584 (includes 307-584/1 and 307-584/2)
Courtesy of FORD MOTOR CO.	Dial Indicator Gauge With Holding Fixture 100-002 (TOOL-4201-C)
Courtesy of FORD MOTOR CO.	Handle 205-153 (T80T-4000-W)
Courtesy of FORD MOTOR CO.	Handle, Torque Converter 307-091 (T81P-7902-C)
Courtesy of FORD MOTOR CO.	Holding Fixture 307-625
Courtesy of FORD MOTOR CO.	Input Shaft Support Seal Installer (Back Plate, Multiple Rings) 307-578 (includes 307-578/1, 307-578/2 and 307-578/3)
Courtesy of FORD MOTOR CO.	Installer, Differential Seal 307-626
Courtesy of FORD MOTOR CO.	Installer, RH Halfshaft Fluid Seal 307-428
Courtesy of FORD MOTOR CO.	Manual Lever Seal Installer 307-581
Courtesy of FORD MOTOR CO.	Retainer, Torque Converter 307-566
Courtesy of FORD MOTOR CO.	Seal Protector, 2-6 Piston 307-632
Courtesy of FORD MOTOR CO.	Seal Protector, Turbine Shaft 307-635
Courtesy of FORD MOTOR CO.	Shim Selection Gauge 307-300 (T94P-77000-Q) (17-055)
Courtesy of FORD MOTOR CO.	Spring Compressor, 2-6 Piston Return 307-633 (Includes 307-633/1 and 307-633/2)