LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transaxle - AISIN Aw21) >> In-Vehicle Repair >> Differential Seals - LH >> Removal

Differential Seals - LH: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: The use of any transmission fluid other than what is recommended for this transaxle will cause transaxle damage.
  1. Remove the LH halfshaft. For additional information, refer to REMOVAL .
  2. Using a suitable awl, poke a small hole in the seal.
    NOTE: Be careful not to damage the case while removing the seal.
    Fig 1: Poking Small Hole In Seal
    G06263972Courtesy of FORD MOTOR CO.
  3. Using a suitable dent puller, remove the LH differential fluid seal.
    Fig 2: Locating LH Differential Fluid Seal
    G06263973Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals