LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transaxle - AISIN Aw21) >> Disassembly And Assembly Of Subassemblies >> Torque Converter Hub Seal >> Disassembly

Torque Converter Hub Seal: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transaxle. For additional information, refer to TRANSAXLE .
  2. Remove the torque converter.
    Fig 1: Installing Torque Converter Hub Seal
    G06264086Courtesy of FORD MOTOR CO.
  3. Using the Input Shaft Oil Seal Remover and Slide Hammer, remove the torque converter hub seal.
    Fig 2: Removing Torque Converter Hub Seal
    G06264087Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals