LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transaxle - AISIN Aw21) >> Disassembly And Assembly Of Subassemblies >> Torque Converter Hub Seal >> Assembly

Torque Converter Hub Seal: Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Position the torque converter hub seal in place.
    Fig 1: Positioning Torque Converter Hub Seal In Place
    G06264088Courtesy of FORD MOTOR CO.
  2. Using the Fluid Pump Seal Installer, install the torque converter hub seal.
    Fig 2: Installing Torque Converter Hub Seal
    G06264089Courtesy of FORD MOTOR CO.
  3. Install the torque converter.
    Fig 3: Locating Torque Converter
    G06264090Courtesy of FORD MOTOR CO.
  4. Install the transaxle. For additional information, refer to TRANSAXLE .
scientia non olet · About LEMON Manuals