Component testing procedure
WARNING: This page is about a different variant/trim than selected.
IGNITION SWITCH - COMPONENT TESTING TABLE
| Circuit to test | Connect self powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Starter relay circuit | 4 and 7 | Off | Open circuit |
| Acc | Open circuit | ||
| Run | Open circuit | ||
| Start | Closed circuit | ||
| Run/Start power circuit | 4 and 1 | Off | Open circuit |
| Acc | Open circuit | ||
| Run | Closed circuit | ||
| Start | Closed circuit | ||
| Run/Acc power circuit | 4 and 6 | Off | Open circuit |
| Acc | Closed circuit | ||
| Run | Closed circuit | ||
| Start | Open circuit | ||
| Key reminder circuit | 4 and 5 | Key In | Closed circuit |
| Key Out | Open circuit | ||
| Key removal inhibit circuit | 4 and 3 | - | 65 - 75? |