LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.5L (Hybrid)) >> In-Vehicle Repair >> Oil Pump Screen and Pickup Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the oil pan. For additional information, refer to Oil Pan, Oil Pump Screen and Pickup Tube  and Removal .
  3. Remove the 2 bolts and the oil pump screen and pickup tube.
    • To install, tighten to 10 Nm (89 lb-in).
    NOTE: Discard the gasket and clean and inspect the gasket mating surfaces.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals