LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.5L (Hybrid)) >> In-Vehicle Repair >> Engine Mount >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the engine coolant degas bottle. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Install the Engine Support Bar to the front and rear engine lifting eyes.
    Fig 1: Installing Engine Support Bar To Front & Rear Engine Lifting Eyes
    G06271876Courtesy of FORD MOTOR CO.
  4. Remove the engine mount bracket bolt.
    • To install, tighten to 115 Nm (85 lb-ft).
  5. Use the Engine Support Bar to raise the engine 25 mm (0.98 in).
    Fig 2: Installing Engine Support Bar To Front & Rear Engine Lifting Eyes
    G06271876Courtesy of FORD MOTOR CO.
  6. Remove the bolt and the ground strap from the engine mount bracket.
    • Tighten to 10 Nm (89 lb-in).
  7. Remove the 3 nuts and the engine mount bracket.
    • To install, tighten to 103 Nm (76 lb-ft).
  8. Remove the 2 bolts and nut and the engine mount.
    • To install, tighten to 55 Nm (41 lb-ft).
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals