LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.5L (Hybrid)) >> In-Vehicle Repair >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using the Camshaft Front Oil Seal Installer, install the crankshaft front oil seal.
    NOTE: Remove the through bolt from the Camshaft Front Oil Seal Installer.
    NOTE: Lubricate the oil seal with clean engine oil.
    Fig 1: Installing Crankshaft Front Oil Seal
    G06094868Courtesy of FORD MOTOR CO.
  2. Install the crankshaft pulley. For additional information, refer to Crankshaft Pulley and Crankshaft Front Oil Seal  and Installation .
scientia non olet · About LEMON Manuals