LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.5L (Hybrid)) >> Disassembly And Assembly Of Subassemblies >> Piston >> Disassembly

Disassembly And Assembly Of Subassemblies: Piston: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the piston rings from the piston.
    • Discard the piston rings.
  2. Remove the 2 piston pin retainers and the piston pin.
  3. Separate the piston from the connecting rod.
    NOTE: If the piston and connecting rod are to be reinstalled, they must be assembled in the same orientation. Mark the piston orientation to the connecting rod for reassembly.
  4. Clean and inspect the piston and connecting rod. For additional information, refer to GENERAL PROCEDURES .
scientia non olet · About LEMON Manuals