LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Evaporative Emissions System (Hybrid)) >> General Procedures >> Evaporative Emission System Leak Test >> Phase 1 - Leak Verification

Phase 1 - Leak Verification

WARNING: This page is about a different variant/trim than selected.
  1. Run the EVAP  Test with the scan tool.
  2. If the Evaporative Emission (EVAP) system failed the EVAP  Test, then proceed to PHASE 2 - System Leak Check .
    NOTE: Some small leaks may not be detected using the EVAP  Test. If the system has passed the test but a leak is still suspected, then proceed to PHASE 2 - System Leak Check .
scientia non olet · About LEMON Manuals