LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Engine Emission Control System - 2.5L (Hybrid)) >> Removal And Installation >> Crankcase Vent Oil Separator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the intake manifold. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Release the coolant bypass hose from the clip.
  3. Remove the 8 bolts and the crankcase vent oil separator and gasket.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
    • Clean the engine block mating surface.
scientia non olet · About LEMON Manuals