LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Accessory Drive System - 2.5L (Hybrid)) >> Removal And Installation >> Accessory Drive Belt >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 4 screws and position the RH fender splash shield aside.
    Fig 1: Locating RH Fender Splash Shield Screws
    G06257214Courtesy of FORD MOTOR CO.
  3. Remove the 6 pin-type retainers and the RH splash shield.
    Fig 2: Locating RH Splash Shield Pin-Type Retainers
    G06272553Courtesy of FORD MOTOR CO.
  4. Remove the A/C hose retainer bracket bolt.
    • To install, tighten to 6 Nm (53 lb-in).
    Fig 3: Locating A/C Hose Retainer Bracket Bolt
    G06272454Courtesy of FORD MOTOR CO.
  5. Rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals