LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Valve Spring, Retainer, and Seal >> Installation

Valve Spring, Retainer, and Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using the Valve Stem Oil Seal Installer, install the new valve seal.
    NOTE: Lubricate the valve guide with clean engine oil.
    Fig 1: Installing Valve Seal
    G06263428Courtesy of FORD MOTOR CO.
  2. Using the Valve Spring Compressor, install the valve spring, retainer and key.
    NOTE: If the components are to be reinstalled, they must be installed in their original positions or damage to the engine may occur.
    Fig 2: Identifying Valve Spring, Retainer & Key
    G06263429Courtesy of FORD MOTOR CO.
  3. Install the camshaft roller followers. For additional information, refer to Removal and Installation .
scientia non olet · About LEMON Manuals