LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position the oil pump and install the bolts.
    • Tighten in the sequence shown below to 10 Nm (89 lb-in).
      • Fig 1: Tightening Oil Pump Bolts
      G06095617Courtesy of FORD MOTOR CO.
  2. Install the oil pump screen and pickup tube. For additional information, refer to ENGINE LUBRICATION COMPONENTS - EXPLODED VIEW  and Installation .
  3. Install the timing drive components. For additional information, refer to Installation .
scientia non olet · About LEMON Manuals