LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the oil level indicator.
  3. If equipped, disconnect the block heater electrical connector and wiring harness retainers.
  4. Remove the stud bolt and the oil level indicator tube.
    • Discard the O-ring seal.
    • To install, tighten to 9 Nm (80 lb-in).
  5. To install, reverse the removal procedure.
    NOTE: Install a new O-ring seal and lubricate with clean engine oil.
scientia non olet · About LEMON Manuals