LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Hydraulic Lash Adjuster >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
  1. Remove the camshaft roller followers. For additional information, refer to Removal and Installation .
  2. Remove the hydraulic lash adjusters.
    NOTE: Mark the positions of the hydraulic lash adjusters to make sure they are assembled in their original positions.
  3. To install, reverse the removal procedure.
    • Lubricate the hydraulic lash adjusters with clean engine oil.
    NOTE: Inspect the hydraulic lash adjusters for scoring marks and uneven wear in the bore. Install new lash adjusters if necessary.
scientia non olet · About LEMON Manuals