LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the engine oil filter.
    • To install, tighten to 5 Nm (44 lb-in) and then rotate an additional 180 degrees.
    NOTE: Lubricate the engine oil filter gasket with clean engine oil prior to installing.
  3. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
  4. Remove the EOP  switch.
    • To install, tighten to 14 Nm (124 lb-in).
  5. To install, reverse the removal procedure.
    • Apply thread sealant with PTFE to the EOP  switch threads.
scientia non olet · About LEMON Manuals