LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply clean engine oil to the seal lip and seal bore before installing the seal.
    NOTE: Clean all sealing surfaces with metal surface prep.
  2. Using the Front Cover Oil Seal Installer and the Crankshaft Vibration Damper Installer, install a new crankshaft front seal.
    Fig 1: Installing Crankshaft Front Seal
    G06095510Courtesy of FORD MOTOR CO.
  3. Install the crankshaft pulley. For additional information, refer to Installation .
scientia non olet · About LEMON Manuals