Removal and Installation

RH side 

1. NOTE: The upper intake manifold must be removed to access the RH ignition coil-on-plugs only.

   Remove the upper intake manifold. For additional information, refer to ENGINE - 3.0L (4V) .

   Both sides 

2. Disconnect the 6 ignition coil-on-plug electrical connectors.
3. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

   Remove the 6 bolts and the 6 ignition coil-on-plugs.

   • To install, tighten to 7 Nm (62 lb-in).
4. To install, reverse the removal procedure.
   • Apply a small amount of dielectric grease to the inside of the ignition coil-on-plug boots before attaching to the spark plugs.