LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Fuel Charging System & Fuel Control System - 3.0L (4V)) >> Removal And Installation >> Throttle Body >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Disconnect the electronic throttle control electrical connector.
  3. Remove the 4 bolts and the Throttle Body (TB).
    • Discard the TB  gasket.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
    NOTE: Install a new TB gasket.
scientia non olet · About LEMON Manuals