LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Automatic Transaxle External Controls (Hybrid)) >> Removal And Installation >> Selector Lever >> Removal

Selector Lever: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the center console. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Disconnect the selector lever cable end from the selector lever.
    Fig 1: Identifying Selector Lever Cable Lever
    G06275674Courtesy of FORD MOTOR CO.
  3. Release the tab on the selector lever cable and remove it from the selector lever housing.
    Fig 2: Identifying Tab On Selector Lever Cable
    G06275675Courtesy of FORD MOTOR CO.
  4. Disconnect the electrical connector.
    Fig 3: Locating Electrical Connector
    G06275783Courtesy of FORD MOTOR CO.
  5. Remove the 4 nuts and remove the selector lever.
    Fig 4: Locating Selector Lever Nuts
    G06275784Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals