LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Electronic Engine Controls (Hybrid)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal

Powertrain Control Module (PCM): Removal

WARNING: This page is about a different variant/trim than selected.
  1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .
  2. Remove the cowl panel grille. For additional information, refer to COWL PANEL GRILLE .
  3. Disconnect the 3 PCM electrical connectors.
  4. Remove the PCM.
    • Remove the lower bolt and the upper PCM bracket bolt.
  5. Remove the bolt and the bracket from the PCM.
scientia non olet · About LEMON Manuals