LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Electronic Engine Controls (Hybrid)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the bracket and bolt on the PCM.
    • Tighten to 11 Nm (97 lb-in).
  2. Install the PCM and the lower bolt.
    • Tighten to 11 Nm (97 lb-in).
  3. Install the upper PCM bracket bolt.
    • Tighten to 11 Nm (97 lb-in).
  4. Connect the 3 PCM electrical connectors.
  5. Install the cowl panel grille. For additional information, refer to COWL PANEL GRILLE .
  6. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .
scientia non olet · About LEMON Manuals