LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Electronic Engine Controls (Hybrid)) >> Removal And Installation >> Manifold Absolute Pressure (MAP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the Manifold Absolute Pressure (MAP) sensor electrical connector.
  2. Remove the screw and the MAP  sensor.
    • To install, tighten to 3 Nm (27 lb-in).
  3. To install, reverse the removal procedure.
    NOTE: Lubricate the MAP sensor O-ring seal with clean engine oil.
scientia non olet · About LEMON Manuals