LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Installation

Stub Shaft Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using the Front Axle Oil Seal Installer and Adapter Handle, install the stub shaft pilot bearing housing seal.
    NOTE: Lubricate the new stub shaft seal with grease.
    Fig 1: Identifying Front Axle Oil Seal Installer And Adapter Handle
    G06065012Courtesy of FORD MOTOR CO.
  2. Install the halfshaft assembly. For additional information, refer to INSTALLATION .
scientia non olet · About LEMON Manuals