LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Drive Pinion Seal >> Installation

Drive Pinion Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using the Pinion Seal Replacer, install the drive pinion seal.
    NOTE: Make sure that the mating surface is clean before installing the new seal.
    Fig 1: Identifying Pinion Sealer Replacer
    G06065003Courtesy of FORD MOTOR CO.
  2. Line up the index marks and position the pinion flange.
    NOTE: Lubricate the pinion flange splines with grease.
    Fig 2: Index-Mark Location Of Pinion Flange
    G06094392Courtesy of FORD MOTOR CO.
  3. Using the Drive Pinion Flange Holding Fixture, install the new pinion flange nut.
    • Tighten to 244 Nm (180 lb-ft).
    Fig 3: Identifying Drive Pinion Flange Holder Fixture
    G06094391Courtesy of FORD MOTOR CO.
  4. Install the driveshaft. For additional information, refer to REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals