LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Transfer Case - Power Transfer Unit (PTU)) >> In-Vehicle Repair >> Cover Seal >> Installation

Cover Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Assemble the Driver Handle, the Halfshaft Oil Seal Installer and the Shaft Bearing Cup Installer as shown in illustration.
    Fig 1: Identifying Driver Handle, Halfshaft Oil Seal Installer & Shaft Bearing Cup Installer
    G06270905Courtesy of FORD MOTOR CO.
  2. Using the Driver Handle, the Halfshaft Oil Seal Installer and the Shaft Bearing Cup Installer, install the cover seal in the PTU.
    Fig 2: Identifying Driver Handle, Halfshaft Oil Seal Installer & Shaft Bearing Cup Installer
    G06270906Courtesy of FORD MOTOR CO.
  3. Install the intermediate shaft seal and deflector. For additional information, refer to Installation .
  4. Fill the PTU as necessary. For additional information, refer to POWER TRANSFER UNIT (PTU) DRAINING AND FILLING .
scientia non olet · About LEMON Manuals