LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Transfer Case - Power Transfer Unit (PTU)) >> Diagnosis And Testing >> Power Transfer Unit (PTU) >> Symptom Table - Power Transfer Unit (PTU) >> Notes

Symptom Table - Power Transfer Unit (PTU): Notes

WARNING: This page is about a different variant/trim than selected.
POWER TRANSFER UNIT (PTU) SYMPTOM TABLE

Condition Possible Sources Action
  • The Power Transfer Unit (PTU) makes noise
  • Tire inflation pressure
  • Tire and wheel size
  • MAKE SURE all tires and wheels are the same size and brand and the inflation pressures are correct.
-
  • Fluid level
-
  • Internal components
  • Leaking fluid from the PTU vent
  • PTU over filled
  • Leaking automatic transmission fluid
  • PTU intermediate shaft seal
  • PTU compression seal
  • Leaking gear lubricant from the seals
  • The PTU vent is plugged (located on top of the PTU)
-
  • Damaged seals
  • Vehicle has no or inadequate torque at rear wheels
  • Rear axle
-
  • PTU mechanical failure
  • Vehicle binds in a turn or resists turning/pulsates or shudders in a straight line
  • Wheels/tires
-
  • Brake system
-
  • Wheel bearings
-
  • Halfshafts
-
  • Wheel speed sensor(s)
-
  • ABS module