LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 989 (Automatic Transmission - Cd4E) >> In-Vehicle Servicing >> Transaxle Support Insulator - Lower, Front >> Installation

Transaxle Support Insulator - Lower, Front: Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new mount onto the cross brace and install the bolts.
    • Tighten to 115 Nm (85 lb-ft).
  2. Position the cross brace in place and install the nut.
    • Tighten to 175 Nm (129 lb-ft).
    3. Fig 1: Identifying Cross Brace And Rear Nut
    G03897887Courtesy of FORD MOTOR CO.
  3. Install the 2 bolts for the cross brace.
    • Tighten to 90 Nm (66 lb-ft).
    4. Fig 2: Locating Cross Brace Bolts
    GF0024803Courtesy of FORD MOTOR CO.
  4. Install the lower front support insulator through bolt for the mount.
    • Tighten to 103 Nm (76 lb-ft).
    5. Fig 3: Locating Mount Through Bolt
    GF0024804Courtesy of FORD MOTOR CO.
  5. Install the rear cross brace and the 4 bolts.
    • Tighten to 115 Nm (85 lb-ft).
    6. Fig 4: Locating Cross Brace & Bolts
    G03900713Courtesy of FORD MOTOR CO.
  6. Install the LH splash shield and the 7 retainers.
    • Tighten to 10 Nm (89 lb-in).
    7. Fig 5: View Of LH Splash Shield And Retainers
    G03900504Courtesy of FORD MOTOR CO.
  7. Install the LH splash shield.
    8. Fig 6: Locating LH Splash Shield
    GF0024802Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals