LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 989 (Automatic Transmission - Cd4E) >> In-Vehicle Servicing >> Transaxle Support Insulator - LH >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the breather tube and mass air flow (MAF) sensor.
    2. Fig 1: Locating Breather Tube & Mass Air Flow (MAF) Sensor
    GF0024765Courtesy of FORD MOTOR CO.
  2. Remove the intake tube and air cleaner cover.
    3. Fig 2: Locating Intake Tube & Air Cleaner Cover
    GF0024766Courtesy of FORD MOTOR CO.
  3. Remove the air cleaner as an assembly.
    4. Fig 3: Locating Air Cleaner Assembly
    GF0024806Courtesy of FORD MOTOR CO.
  4. Install the special tools.
    5. Fig 4: Drivetrain Support Tool
    GF0024808Courtesy of FORD MOTOR CO.
  5. Install the special tools.
    6. Fig 5: Identifying Special Tools
    GF0024809Courtesy of FORD MOTOR CO.
  6. Remove the upper transaxle mount through bolt.
    • To install, tighten to 103 Nm (76 lb-ft).
    7. Fig 6: Locating Upper Transaxle Mount Through Bolt
    GF0024810Courtesy of FORD MOTOR CO.
  7. Remove the 4 upper transaxle mount bolts and remove the mount.
    • To install, tighten to 48 Nm (35 lb-ft).
    8. Fig 7: Locating Upper Transaxle Mount Bolts & Mount
    GF0024811Courtesy of FORD MOTOR CO.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals