LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 935 (MULTIFUNCTION Electronic Modules System) >> Diagnostic Tests >> Smart Junction Box (SJB) >> Pinpoint Tests >> Pinpoint Test A: DTC B106E - Solid State Driver Disabled Due To Short Circuit >> Pinpoint Test A: DTC B106E - Solid State Driver Disabled Due To Short Circuit

Pinpoint Test A: DTC B106E - Solid State Driver Disabled Due To Short Circuit

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: If DTC B106F is present and the SJB is to be replaced, the fault condition must be corrected first. Failure to correct the fault condition first may cause damage to the new SJB, resulting in a repeat repair.
  1. A1 REVIEW THE DTCs 
    • Review the DTCs from the SJB self-test.
    • Are only DTC B106E and DTC B106F present? 
    1. YES  : INSTALL a new SJB. REFER to Smart Junction Box (SJB) . TEST the system for normal operation.
    2. NO  : CORRECT any DTCs present other than DTC B106E and DTC B106F. REFER to Diagnostic Trouble Code (DTC) Chart . After the repair, go to  A2 .
  2. A2 CARRY OUT THE SJB SELF-TEST 
    • Carry out the SJB self-test.
    • Is DTC B106F present? 
    1. YES  : INSTALL a new SJB. REFER to Smart Junction Box (SJB) . TEST the system for normal operation.
    2. NO  : The system is operating correctly at this time. The concern was caused by a fault in one of the output circuits.
scientia non olet · About LEMON Manuals