LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 925 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Liftgate Latch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  2. Disconnect the liftgate ajar switch electrical connector.
  3. Disconnect the liftgate latch actuating rod.
    1. Open the clip.
    2. Disconnect the actuating rod.
    4. Fig 1: Liftgate Latch Actuating Rod & Clip
    GF0023828Courtesy of FORD MOTOR CO.
  4. Remove and discard the 3 liftgate latch bolts.
    • To install, tighten to 12 Nm (9 lb-ft).
    5. Fig 2: Liftgate Latch Bolts
    GF0023829Courtesy of FORD MOTOR CO.
  5. Remove the liftgate latch.
  6. To install, reverse the removal procedure.
    • Lubricate the liftgate latch to striker surfaces with Krytox grease after installation.
scientia non olet · About LEMON Manuals