Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Disconnect the breather tube and mass air flow (MAF) sensor.

Fig 1: Locating Breather Tube & Mass Air Flow (MAF) Sensor

Courtesy of FORD MOTOR CO.

Remove the intake tube and air cleaner cover.

Fig 2: Locating Intake Tube & Air Cleaner Cover

Courtesy of FORD MOTOR CO.

Remove the air cleaner assembly.

Fig 3: Locating Air Cleaner Assembly

Courtesy of FORD MOTOR CO.

Remove the mount through bolt.
- To install, tighten to 120 Nm (89 lb-ft).
Remove the retaining bolt and the 2 nuts for the mount and remove the mount.
- To install, tighten to 80 Nm (59 lb-ft).
To install, reverse the removal procedure.