LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 832 (MULTIFUNCTION Electronic Modules -- F250-F550 Super Duty) >> Removal And Installation >> Upfitter Relay Box >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upfitter switch assembly. For additional information, refer to Upfitter Switch  in this article.
  2. Releasing the glove compartment stops, lower the glove compartment.
  3. Remove the 2 screws and position the upfitter relay box aside.
  4. Release the 2 tabs and remove the upfitter relay box from the bracket.
  5. Remove the ground bolt.
  6. Release the wiring harness locators and remove the upfitter relay box and harness assembly from the instrument panel.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals