LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 823 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat - Front, Bucket and 40 Percent >> Removal And Installation >> Manual seats

Manual seats

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat.
    • Remove and discard the 2 front seat riser support-to-floor bolts.
      • To install, tighten to 55 Nm (41 lb-ft).
    • Disconnect the safety belt buckle electrical connector (driver only).
    • Remove the 2 rear seat riser support-to-floor pan nuts.
      • To install, tighten to 55 Nm (41 lb-ft).
    • Remove the front seat.
    Fig 1: Locating Front Seat Riser Support-To-Floor Bolts
    GF0004971Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals