LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 817 (Body Panel System - Front End Body Panels -- F250-F550 Super Duty) >> Removal And Installation >> Fender >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Support the hood using a prop rod.
  2. Disconnect the hood lift.
    3. Fig 1: Disconnecting The Hood Lift
    GF0004764Courtesy of FORD MOTOR CO.
  3. Remove the headlamps and turn signals. For additional information, refer to EXTERIOR LIGHTING article.
  4. Remove the screws at the lower edge of the front fender securing the splash shield.
    5. Fig 2: Removing Splash Shield Screws
    GF0004765Courtesy of FORD MOTOR CO.
  5. Remove the running board, if so equipped. For additional information, refer to EXTERIOR TRIM AND ORNAMENTATION article.
  6. Remove the pushpins at the rear lower edge of the front fender.
  7. Remove the bolts securing the lower rear of the front fender.
    8. Fig 3: Removing The Bolts Securing The Lower Rear Of The Front Fender
    GF0004766Courtesy of FORD MOTOR CO.
  8. Remove the fender-to-radiator grille opening support retaining bolts.
    9. Fig 4: Removing The Fender-To-Radiator Grille Opening Support Retaining Bolts
    GF0004767Courtesy of FORD MOTOR CO.
  9. Remove the fender-to-radiator support retaining screws.
    10. Fig 5: Removing The Fender-To-Radiator Support Retaining Screws
    GF0004768Courtesy of FORD MOTOR CO.
  10. Open the door, then remove the fender retaining bolts.
    11. Fig 6: Removing The Fender Retaining Bolts
    GF0004769Courtesy of FORD MOTOR CO.
  11. Remove the upper fender retaining bolts.
    12. Fig 7: Removing The Upper Fender Retaining Bolts
    GF0004770Courtesy of FORD MOTOR CO.
  12. Remove the hood support bolt.
    13. Fig 8: Removing The Hood Support Bolt
    GF0004771Courtesy of FORD MOTOR CO.
  13. Remove the front fender.
  14. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals