LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 780 (Driveshaft -- F250-F550 Super Duty) >> Removal And Installation >> Driveshaft - Rear, One-Piece, Four Wheel Drive (4WD) >> Installation >> Vehicles with split pin yoke

Vehicles with split pin yoke

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Align the index marks.
  1. Position the bearing cups in the rear axle pinion flange.
    2. CAUTION: Install new bolts and new retainers.
  2. Install the 2 new retainers and 4 new rear driveshaft-to-axle bolts.
    • Tighten to 35 Nm (26 lb-ft).
Fig 1: Locating Rear Driveshaft-To-Axle Bolts
GF0006231Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals