LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 754 (Fuel Tank And Fuel Lines - F-150 & Mark LT) >> Removal And Installation >> Inertia Fuel Shutoff (IFS) Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH lower A-pillar trim panel.
  2. Disconnect the inertia fuel shutoff (IFS) switch electrical connector.
  3. Remove the 2 IFS bolts and the IFS switch.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals