Removal And Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make sure the headlamp switch and the ignition switch are in the OFF position.
- Remove the radiator side air deflector.
- Remove the pin-type retainer.
- Remove the 3 bolts.
- To install, tighten to 5 Nm (44 lb-in).
- Lift up on the retaining tab and pull the headlamp assembly straight out to prevent damage to the retainer and the locator pin.
- Disconnect the electrical connectors.
- To install, reverse the removal procedure.