Pinpoint Test E: An Individual Demand Lamp Is Inoperative
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- E1 CHECK CIRCUIT 54 (LG/YE) FOR AN OPEN NOTE: The battery saver relay must be activated during this test.
- Key in OFF position.
- Disconnect: Suspect Demand Lamp.
- Measure the voltage between the inoperative demand lamp, harness side and ground as follows:CONNECTOR-PIN CIRCUIT
Inoperative Lamp Connector-Pin Circuit Underhood lamp C1159-1 54 (LG/YE) RH vanity mirror lamp C906-1 54 (LG/YE) LH vanity mirror lamp C907-1 54 (LG/YE) Front dome/map lamp (Crew Cab or SuperCab) C931-3 54 (LG/YE) Rear dome/map lamp (Crew Cab or SuperCab) C932-3 54 (LG/YE) Interior/map lamp (regular cab) C932-3 54 (LG/YE) Overhead console (if equipped) C9013-8 54 (LG/YE) - Is the voltage greater than 10 volts?
Yes : GO to E2.
No : REPAIR circuit 54 (LG/YE). TEST the system for normal operation.
- E2 CHECK CIRCUIT 57 (BK) FOR AN OPEN
- Measure the resistance between the inoperative demand lamp, harness side and ground as follows:CONNECTOR-PIN CIRCUIT
Inoperative Lamp Connector-Pin Circuit Underhood lamp C1159-2 57 (BK) RH vanity mirror lamp C906-2 57 (BK) LH vanity mirror lamp C907-2 57 (BK) Front dome/map lamp (Crew Cab or SuperCab) C931-2 57 (BK) Rear dome/map lamp (Crew Cab or SuperCab) C932-2 57 (BK) Interior/map lamp (regular cab) C932-2 57 (BK) Overhead console (if equipped) C9013-9 57 (BK) - Is the resistance less than 5 ohms?
Yes : INSTALL a new demand lamp. TEST the system for normal operation.
No : REPAIR circuit 57 (BK). TEST the system for normal operation.
- Measure the resistance between the inoperative demand lamp, harness side and ground as follows: