LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 456 (Accessory Drive System - F250-F550 Super Duty) >> Removal And Installation >> Accessory Drive Belt Tensioner - 6.0L Diesel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cooling fan stator - 6.0L diesel engine. For additional information, refer to ENGINE COOLING .
  2. Rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt.
    Fig 1: Rotating Accessory Drive Belt Tensioner Clockwise
    G03887093Courtesy of FORD MOTOR CO.
  3. Remove the 2 bolts and the accessory drive belt tensioner.
    • To install, tighten to 25 Nm (18 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals