Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING:
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING:
Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
- Remove the Evaporative Emission (EVAP) canister assembly. For additional information, refer to EVAPORATIVE EMISSION CANISTER .
- Disconnect the fuel vapor vent-to- EVAP canister quick connect coupling. For additional information, refer to QUICK CONNECT COUPLING .
- Disconnect the fuel vapor vent valve electrical connector.
- Remove the fuel vapor vent valve from the EVAP canister tray.
- To install, reverse the removal procedure.
- Carry out the Evaporative Emission System Leak Test. For additional information, refer to EVAPORATIVE EMISSION SYSTEM LEAK TEST .