Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The LH temperature blend door actuator is present on dual-zone Electronic Automatic Temperature Control (EATC) vehicles to control the LH temperature blend door only. Vehicles equipped with Electronic Manual Temperature Control (EMTC) are not equipped with this actuator. For EMTC
vehicles, refer to TEMPERATURE BLEND DOOR ACTUATOR - RH .
- Disconnect the LH temperature blend door actuator electrical connector.
- Remove the 2 LH temperature blend door actuator screws.
- To install, tighten to 3 Nm (27 lb-in).
- Remove the LH temperature blend door actuator.
- To install, reverse the removal procedure.